The Hayward Fault extends from San Pablo Bay where it joins up with the Rodgers Creek Fault, to south of San Jose, where it merges with the Calaveras Fault, a length of 140 mi (230 km). The Calaveras Dam will be one of the largest dams built in the State of California within the last 30 years. The Green Valley fault (GVF), a branch of the dextral strike-slip San Andreas fault system, connects the Northern Calaveras fault (NCF) to the Bartlett Springs fault (BSF) to the north. Following is a brief description of some of the most important faults. We measure peak ground velocities from fault‐zone guided waves (FZGWs), generated by on‐fault earthquakes associated with the 24 August 2014 Mw 6.0 South Napa earthquake. The abrupt increase in line length identified by the letter E appears to be a coseismic response associated with a magnitude 5.9 earth quake approximately 25 km NNW of Hollister, California, on the Calaveras fault (Coyote Lake). moment within a fault length interval, 9if0 z (L), and the fault length L On the Calaveras fault (Fig. Because the faults are connected, an earthquake starting on one fault could easily continue along the other. The red line is the newly discovered surface trace connecting the southern end of the Hayward Fault to the Calaveras Fault, once thought to be an independent system. The white lines indicate faults recognized by the USGS. The new dam will be 67 m high, with a length at crest of 370 m and a width at the base of 360 m. Calaveras Dam California, USA. The white lines indicate faults recognized by the USGS. However, many scientists believe that the Hayward Fault is connected to the Calaveras Fault to the south, the Rodgers Creek Fault to the north and to the Maacama Fault still farther north. The dam is designed to withstand a 7.25 magnitude seismic event; the dam sits atop the Calaveras Fault, an active fault located only 1,500 ft. from the dam axis. 2A) and in the Loma Prieta area (Fig. 2A and B. When I first added this ride to my site, parts of this ride were as new as they come.On the date of my first ride here in January 2012, the stretch of Sierra Vista Trail between Boccardo Loop and Calaveras Fault Trail was less than three months old.What felt more important was that … During the 1979 and 1984 earthquake sequences, the Calaveras fault zone ruptured in the subsurface along a total length of 45 km extending to the southeast from Mt. Sierra Vista and Calaveres Fault Trail is a 9.5 mile lightly trafficked out and back trail located near San Jose, California that features beautiful wild flowers and is rated as difficult. The researchers found that the underground portion of the Hayward Fault meets the Calaveras Fault 10 kilometers farther north than where the creeping surface traces of both faults meet. The new dam will be 67 m high, with a length at crest of 370 m and a width at the base of 360 m. Like the other faults in the system the Calaveras is a right-lateral, strike-slip fault. CALAVERAS FAULT ZONE The Calaveras fault zone is part of a system of active faults which branch from the San Andreas fault south of Hollister. The Calaveras Fault and lost seismograms . calculated from fault length using Sleramon's (1977) linear regressions of earthquake magnitude on length of surface rupture: for strike-slip faults, M = 0.597 + 1.351 log1Q(L) for reverse faults (including thrust faults), M - 4.145 + 0.717 log10(L) and for normal faults M = 1.845 + 1.51 log^(L) where M is magnitude and L is fault length in meters. Hence the combined Hayward-Rodgers Creek Fault is capable … Creep on the north and central CF is not as well constrained because the fault traces largely lie in vegetated and hilly terrain, limiting remote sensing capabilities, and only nine AAs exist on this fault over a length of CHAUSSARD ET AL. It is about 100-150 miles in length. The Calaveras Fault is a major branch of the San Andreas Fault System that is located in northern California in the San Francisco Bay Area.Activity on the different segments of the fault includes moderate and large earthquakes as well as aseismic creep.The last large event was the 1984 Morgan Hill event and the last moderate earthquake was the 2007 Alum Rock event. Although, the GVF may occasionally rupture along its entire length to produce M7 earthquakes, 2-3 km discontinuities in its trace appear to modulate the length and frequency of ruptures. With a slip rate of about 15 mm/yr (0.6 in/yr) and a length of about 100 km (60 mi), the Calaveras is highly active and certainly capable of a M7+ earthquake. The Sierra Vista Trail opened in 2011, connecting the Ridge Trail at the lower elevations with the Upper and Lower Calaveras Fault Trails, and creating a long 8.9-mile Ridge Trail segment. The trail is primarily used for hiking, running, and nature trips. A fault’s length is related to the maximum strength of an earthquake it can produce. These faults separate the rocks of the Western Metamorphic Belt into many discrete fault-bounded units. The combined Hayward-Rodgers Creek fault has a length of more than 110 miles. Gravity and magnetic investigations of the Calaveras Fault (CF) present an image of a San Andreas system strike-slip fault that is highly variable along strike, both in offset accommodation and geometry. Hamilton. It will replace the existing dam, which has been operating since 1925. In 1868, the population living along the Hayward Fault was just 24,000. The fault cuts through the towns of Walnut Creek, San Ramon, Dublin, Pleasanton, Sunol, and Hollister. the summed moment increases linearly with fault length. The Calaveras Dam will be one of the largest dams built in the State of California within the last 30 years. The Hayward Fault is considered one of the most powerful fault lines in the world, running parallel to the potentially catastrophic San Andreas fault, and 150 years almost to the day, researchers warn it is overdue a quake. Along most of the length of the creeping segment, this offset occurs within a narrow (<2 km) zone close to the fault trace. HAYWARD-CALAVERAS INTERSEISMIC COUPLING 8570 PUBLICATIONS Journal of Geophysical Research: Solid Earth It starts about 15 miles east of Salinas at the San Andreas and continues northward toward Oakland, where it becomes the Hayward Fault. The Bay Area fault system and the spot (red star) where the Hayward Fault branches off from the Calaveras Fault. We identify REs on the Calaveras fault by first cross-correlating all pairs of events with epicentral separations of up to 10 km within our study area ().Vertical component, short-period Northern California Seismic Network (NCSN) waveforms, sampled at 100 samples/sec, from stations up to 50 km away from the fault are used in this analysis. Generalized from Herd and McCulloch, 1983. It makes up one of the larger faults within the San Andreas Fault System, and has … January 2, 2021; Uncategorized; 0 Comments The system may extend along the entire length of the northern Coast Ranges (Herd, 1978). The Calaveras Fault is an offset of the San Andreas Fault network. Calaveras Dam California, USA. Principal active faults of central California; study area (Figure 2) is the region along the Calaveras fault near the epicenter of the Coyote Lake earthquake. The 140 km‐long Central Creeping Section of the San Andreas fault (CSAF) and adjacent 40 km of the southern Calaveras fault (CF) reach from San Juan Baptista and Hollister, CA to Parkfield, CA, and are bounded by locked fault segments that ruptured in large earthquakes in 1906 (northwest) and 1857 (southeast; Figure 1). The relation Yff0 z (L)--L is shown as a dotted line in figs. The Calaveras Dam will be one of the largest dams built in the State of California within the last 30 years. The Bay Area fault system and the spot (red star) where the Hayward Fault branches off from the Calaveras Fault. The Hayward Fault Zone is a geologic fault zone capable of generating destructive earthquakes.This fault is about 74 mi (119 km) long, situated mainly along the western base of the hills on the east side of San Francisco Bay.It runs through densely populated areas, including Richmond, El Cerrito, Berkeley, Oakland, San Leandro, Castro Valley, Hayward, Union City, Fremont, and San Jose. The Hayward Fault is thought capable of generating a magnitude 7.5 quake. 2B) the summed moment approximately doubles as the fault length doubles, i.e. Herein, how long is the Calaveras Fault? In Hollister, the fault is creeping which means that it moves constantly, at a steady rate. The Calaveras-Paicines fault zone is more than 170 km in length, extending northward through Hollister FIG. The red line is the newly discovered surface trace connecting the southern end of the Hayward Fault to the Calaveras Fault, once thought to be an independent system. One current assumption is that if the Hayward Fault has a major quake every 140 years, it’s possible that the Hayward and Calaveras rupture together only once every 1,000 or 2,000 years. In the northern part, a minor part of the offset is taken up by the nearby Calaveras-Paicines Fault. Calaveras Dam California, USA. The data were recorded on three arrays deployed across north and south of the 2014 surface rupture. This rupture occurred mainly at earthquake depths of 1 to 10 km below the surface, according to focal depths determined by the U. S. Geological Survey. 1. what type of fault is the calaveras fault. The new dam will be 220 feet high, with a length at crest … for the entire length of the metamorphic belt. It will replace the existing dam, which has been operating since 1925. The total contribution of the Rodgers Creek–Maacama fault system to slip of the East Bay fault system south of San Pablo Bay since 7.0 ± 0.3 Ma appears to be >48.4 ± 1.4 km, for a median long-term slip rate of at least 6.95 ± 0.85 mm/yr. The Hayward Fault extends from San Pablo Bay where it joins up with the Rodgers Creek Fault, to south of San Jose, where it merges with the Calaveras Fault, a length of 140 mi (230 km). It will replace the existing dam, which has been operating since 1925.